0:00
Alright, here's my tipping wheel setup
0:05
And we're doing a little special tipping. So we had to set up a special little deal
0:11
And we already did one run. Jason is working on this VW hood
0:17
Let's get Jason into the picture. Is Jason? And that was the first run on the VW hood for the go-cott
0:25
the aluminum body. Jason's done the whole entire deal. Now we've got to emboss that or joggle that other side
0:34
We needed these little small little wheels on the tipping wheel and wanted to make this real tight turn right there
0:42
So, okay, Jason, you can engage that in there. And see if we can get that to go
0:50
I want to be turning the wheel. Jason's going to be running the panel. And Kurt is running the camera
0:57
Just watch those numbers at the top there. You ready, Jason? Yep All right we going to crank it down
1:15
All right, so I'll crank it and tighten it until we get the right depth
1:24
I should have noted where that red ball was. We'll go over and again now
1:30
That look good? good yeah looks good that's good now uh the depth depth looks pretty good yes okay
1:40
my jason staring it and i'm slowly wheeling it through Coming up to the radius
2:03
It's a tight little tricky corner here. Tight radius. We got to go real slow Oh lights just right It good we good
2:21
You got it? Yeah. Got it. Looks good. We'll go slow
2:55
We had to make this special setup so that the flange on the side of the hood
3:10
wooden file on the machine. The way we usually have it, it was hitting
3:16
You couldn do this on a standard bead roller at all Good luck trying to do this on a pull max It be a fun little
3:28
operation, I'm sure. All right, we're good. We're done. All right, let's take off the tape and see what we got
3:40
Use the one eighth inch vinyl tape. We'll post this on a Volkswagen for them
4:02
With the VW guys would approve of this. There you go. Yeah, that's beautiful
4:07
We've got a suniline tape on here. We'll take that off. We're going to make a nice little custom copper or brass VWM
4:17
W. M. We're going to put it on right there. But that's it. Nice job, Jason. Thank you
4:27
Just at the stop button there. There is it. All right
